3. Select Save.
Display All Video Calls in Full Screen Mode
By default, the far-side video always displays in the Active Call screen. You can enable your phone to
display all incoming videos on the full screen.
Procedure
1. Go to Settings > Basic > Video.
2. Select Video Call Settings and select Auto Video Full Screen > Enable.
When enabled, this setting automatically enables your phone to display far-side video in full
screen. When disabled, far-side video is displayed in the smaller Active Call screen.
3. Select Save.
Place a Video Call
If your phone is set to transmit video automatically for calls, then your video stream is sent for all calls
placed on your phone. If your phone is set to place audio-only calls by default, you can start video during
an active call.
Procedure
1. Tap New Call, enter a number or select a contact, and tap or Send.
2. After your contact answers, press the Video or Start Video soft key.
Your camera transmits video to your contact. On phones with a USB camera, the LED light is
green when video is transmitting.
Swap Video
You can switch the locations of your video and the far-side video. If you do this, your PIP is displayed in
the Active Call screen, and the far-end video, previously displayed in the Active Call screen, is displayed
in the PIP location. When you swap video so that your video is displayed in the Active Call screen, rather
than in the PIP, the message “Local camera” is displayed next to your video.
Procedure
» During a video call, do one of the following:
• Tap Video > Swap.
• Tap the PIP.
Display Video Calls in Full Screen
You can display the far-side video full screen. Your picture-in-picture (PIP) continues to display in the
corner with the softkeys hidden. In full screen, call details display along the bottom of the screen,
including an icon that you can select to exit full screen mode. The following figure displays full screen
video on the phone.
Video Calls on Poly VVX
89
To Next Page
Loading...
