PREVOST X3-45 User Manual

Technical Information 143
ON MESSAGES CENTER
DISPLAY (MCD)
SAE-J1587 Codes
ON SHIFT SELECTOR
DISPLAY
ISO CODES WITH
TESTMAN TOOL
DESCRIPTION
251,0 FB 104 High voltage (Vehicle electrical system voltage too high)
251,1 FD 105 Low voltage (Vehicle electrical system voltage too low)
253,14 FD 190 EOL EEPROM parameter out of valid range
253,14 FD 191 EOL EEPROM parameter checksum error
254,12 FE 169 Cut-off relay in ECU does not switch off
254,13 FE 170 No voltage supply at pin 30 or cut-off relay in ECU does not switch on
254,14 FE 188 ECU fault - wrong interrupt
254,14 FE 189 ECU fault - stack watch
254,14 FE 192
ECU fault - EEPROM access failure (or first power-up after programming without
managed power down cycle)
254,14 FE 90 Communication error between controller 1 and controller 2 (ECU failure)
- FF - ZMTEC does not recognise the ISO fault code

PREVOST X3-45 Specifications

General

Brand	PREVOST
Model	X3-45
Category	Buses
Language	English