Care and Maintenance
103
AIR BELLOWS 01069
For belt replacement, air pressure must be
released from bellows by means of the belt
tensioning pressure control valve. This valve,
mounted close to the pressure regulating valve,
is manually operated. Before handling, set the
rear start switch to OFF and observe all
applicable safety precautions.
• Refer to the Parts Manual, Maintenance
Manual or "Service Bulletins" for
recommended belt sizes and tension
settings;
• Periodically inspect belt and pulleys for wear
or damage;
• Do not treat belts with any compounds.
Keep belts dry.
PRESSURE REGULATING VALVE 12200
BACK-UP CAMERA
The optional back-up camera is located on the
rear cap. To clean the camera's protective glass,
spray with soapy water. Wipe with a clean damp
rag or wiper blade.
WARNING
To avoid injury, do not clean camera with
transmission in reverse (R). Shut off engine
and apply parking brake before cleaning.
CAUTION
To prevent scratches to the camera protective
glass, do not wipe with dry rag. Use a clean
damp rag.
AIR FILTER RESTRICTION INDICATOR
A filter restriction indicator (optional) is used to
monitor the vacuum level between the air filter
and engine. A red marker is displayed when the
air filter is clogged. When a red marker is
displayed, the air filter must be replaced. Reset
by pressing on the indicator's extremity.
The filter restriction indicator is located on the
engine air intake duct
RESTRICTION INDICATOR 01052
A/C AND HEATING SYSTEM AIR FILTERS
For maximum air conditioning and heating
system efficiency, air filters should be inspected
and cleaned as required in maintenance
schedule to ensure proper ventilation of the
evaporator and heating radiator cores. To clean
filters, back flush with water, then dry with air.
CAUTION
Do not use high pressure water jet to avoid
damaging filter.
To Next Page
Loading...
