EasyManua.ls Logo

PREVOST X3-45 - Back-Up Camera; 110-120 Volts Connector; Hubodometer

PREVOST X3-45
161 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Coach Exterior
13
To provide good visibility in cold weather, the
mirrors can be equipped with heating elements.
The elements are activated by a rocker switch
located on the dashboard. Refer to "Controls &
Instruments" chapter. Thermostats are used to
prevent continuous operation of the heating
elements.
CAUTION
Do not attach stick-on type convex mirror
accessories to the heated mirror glass. This
could impede uniform heat distribution on the
mirror surface and could break the mirror
glass.
The mirrors are adjusted using the controls
located on the L.H. control panel. Refer to
"Controls & Instruments" chapter. Manual
adjustment is also possible.
BACK-UP CAMERA
An optional back-up camera is available which
provides the driver with visual assistance when
backing-up. Camera monitor is installed on the
dashboard L.H. side, on the windshield post. For
additional information, refer to "Controls &
Instruments".
110-120 VOLTS CONNECTOR
This connector is connected to the electric block
heater and uses a 110-120 VAC power source.
It is located near the engine compartment rear
doors release handle. (refer to chapter “Starting
and Stopping Procedures”).
PRISE DE 110-120 VOLTS 06390
HUBODOMETER
An odometer is installed on the curb-side drive
axle wheel hub. The odometer calculates the
total distance in miles or kilometers (depending
on model installed) traveled by the coach since
manufacture, including factory road testing.
NOTE
It is normal for the hubodometer, the DDEC
ECM and the vehicle odometer to disagree on
the total mileage.
HUBODOMETER 13012

Table of Contents

Related product manuals