ProMinent DULCOMETER - Commissioning; Switch-on behaviour during commissioning

Mode Selection of the Modbus communication
mode. On this selection button you will find the
information of the selected mode (e. g. RTU).
Speed Selection of the Modbus communication
speed. On this selection button you will find
the information of the selected speed (e. g.
19200).
Parity Selection of the Modbus communication
parity. On this selection button you will find the
information of the selected parity (e. g. None).
Stop bit(s) Information on the configuration of the number
of stop bit(s). This option is not configurable, it
adapts according to the parity configuration
and here is just information to help you con‐
figure your connection.
Address Modbus address input of your controller. Press
it to open the numeric keypad and enter the
desired value. Possible adjustment from 1 to
247.
Port TCP port selection. On this selection button
you will find the information of the selected
port (e. g. 520).
Simultaneous
connection(s)
Selection of the number of simultaneous
Modbus connection(s). On this selection
button you will find the number of simulta‐
neous connections.
Peripheral Selection of the Modbus communication
device. On this selection button you will find
the information of the selected device (WIFI).
Pseudo address Selection of the pseudo Modbus communica‐
tion address. On this selection button you will
find the information of the selected pseudo
address (e. g. 255).
Do not forget to configure the WiFi parameters, if
the device associated with your Modbus is WiFi
type.
General Menu
50