Chapter 6: Tekterm Application
ANSI Settings
268
Psion Teklogix 7535/7530 Hand-Held Computer User Manual
6.19.1 ANSI Settings
Each session you create has its own “Settings” parameters. Additional ANSI
information is documented in “ANSI Emulation” on page 236.
Auto Term#
Note: Refer to “Group” on page 268 for additional instructions.
When this parameter is set to “Y”, a unique number is assigned for the current ANSI
session. If “Auto Term#” is set to “Y”, any value assigned to the “Terminal #”
parameter is ignored.
Note: “Auto Term#” is available when
802.IQv2 is assigned to the “Host
Conn” parameter or when
802.IQv1 is enabled in the Radio Menu (see
“802.IQ v1” on page 253).
Group
When “Auto Term#” is set to “Y”, the ‘Group’ parameter is used to identify the
group or pool of numbers from which an auto-address is chosen.
Terminal #
For every application session you create, the “Terminal #” assigned must be
non-zero and unique. This parameter defines the number for the ANSI session and
uniquely identifies all transmissions to and from the 7535/7530.
Auto Term # N» see text
Terminal # 1 1..1024
Host Conn » see text
Screen » see text
Xmit Modes » see text
Kbd Modes » see text
Edit Modes » see text
Serial » see text
Host Char Set » see text
Anchor View N» see text
Ansi
Range
04
Group 1 1-5
Range
Auto Term#
To Next Page
