SECTION 5
TROUBLESHOOTING
71
Touchscreen Messages (continued)
The Touchscreen will display messages to alert you to problems or to indicate a process is finished.
NO ENCODER SIGNAL
(ERROR 05)
Printer Motor has stopped.
Wire Harness connection is loose
or broken.
Encoder Belt worn or broken.
Encoder Sensor not working.
Check/clear possible Jam.
Press OK to continue.
Properly shutdown and cycle
printer power.
If problem persists contact
Service Support.
STOP TIME OUT (ERROR 06)
Printer Transport was left
running and automatic 5-minute
timeout has started.
Press OK to restart transport
before continuing to print.
To Next Page
Loading...
