CHAPTER TITLE WEB GRAPHICAL USER INTERFACE (GUI) FOR ESMS
4-39
Procedure:
1. In the LAN Destination Tab, choose the slot to be config-
ured. This should be the same slot that you have selected
in the Alert Policy Entry- Destination Selector field. That is
if you have chosen the Destination Selector as 4 in the
Alert Policy Entry page of Alert Policy Tab, then you have
to configure the 4th slot of LAN Destination Page.
2. Select the slot and click Add. This opens the Add LAN
Destination entry.
Figure 4-29. Add LAN Destination entry Page
3. In the LAN Destination field, the destination for the
newly configured entry is displayed and this is a read only
field.
4. In the Destination Type field, select the one of the types.
5. In the Destination Address field, enter the destination
address.
Table 4-26: PEF Management - LAN Destination
I
TEM DESCRIPTION
LAN Destination
Displays Destination number for the newly
configured entry (read-only).
Destination Type
Destination type can be either an SNMP Trap or
an Email alert.
For Email alerts, the 3 fields - destination Email
address, subject and body of the message
needs to be filled. The SMTP server information
also has to be added - under
Configuration
> SMTP.
For SNMP Trap, only the destination IP address
has to be filled.
Destination Address
If Destination type is SNMP Trap, then enter the
IP address of the system that will receive the
alert. Destination address will support the
following:
IPv4 address format.
IPv6 address format.
If Destination type is Email Alert, then give the
email address that will receive the email.
Subject & Message
These fields must be configured if email alert is
chosen as destination type. An email will be sent
to the configured email address in case of any
severity events with a subject specified in
subject field and will contain the message field's
content as the email body.
Add
To save the new LAN destination and return to
LAN destination list.
Cancel
To cancel the modification and return to LAN
destination list.
To Next Page
Loading...