QUANTA STRATOS S210 Series S210-X22RQ - Removing an iBBU

INSTALLING HARDWARE REMOVING AN IBBU
2-42
5. Secure the iBBU holder to the module with four (4)
screws.
Figure 2-62. Installing the iBBU Holder to the Module
6. Connect the iBBU cable to the battery.
7. Connect the iBBU cable to the expansion card.
Removing an iBBU
Prerequisite:
Prerequisite:
Remove the top cover. See Removing the Top Cover on
page 2-8.
1. Disconnect the iBBU cable from the card.
2. Disconnect the iBBU cable from the battery.
3. Remove two (2) screws securing the iBBU assembly to
the air duct.
Figure 2-63. Removing the iBBU Assembly
4. Remove the iBBU battery holder from the module.
Note:
The iBBU can be connected to either a mezzanine card or a
PCI-E expansion card.