QUANTA STRATOS S210 Series S210-X22RQ - Hard Drives

INSTALLING HARDWARE HARD DRIVES
2-2
2.2 Hard Drives
Removing a 2.5” Hard Drive
Figure 2-1. Opening the 2.5” Hard Drive Tray Handle
1. Press the tray handle button.
Figure 2-2. Removing a 2.5” Hard Drive Tray
2. Pull the HDD tray handle completely open.
3. Grasp the tray handle and pull the tray out of the
system.
WARNING!
Do not operate the system without all hard drive trays
inserted into the chassis. All hard drive bays must be
occupied by either a hard drive or an empty hard drive
tray. Hard drives may be removed while the system is
operational but should be immediately replaced by
another hard drive or an empty hard drive tray.
!
WARNING!
Make sure the tray handle is in the fully open position.
2
3
!