QUANTA STRATOS S210 Series S210-X22RQ - Mainboard Module

INSTALLING HARDWARE MAINBOARD MODULE
2-23
2.9 Mainboard Module
Removing a Mainboard Module
Prerequisite:
Prerequisite:
Remove the top cover. See Removing the Top Cover on
page 2-8.
Disconnect all cables from mainboard.
1. Remove eight (8) screws securing mainboard to chassis.
Figure 2-29. Removing the Mainboard Module Screws
2. Lift the front end of the mainboard until free of the chassis
guide pin.
Figure 2-30. Aligning to the Chassis Guide Pin