SAFETY INFORMATION SYSTEM ACCESS WARNINGS
9-4
Power Cord Warnings
If an AC power cord was not provided with your product, pur-
chase one that is approved for use in your country.
System Access Warnings
TO AVOID ELECTRICAL SHOCK OR FIRE, CHECK THE POWER
CORD(S) THAT WILL BE USED WITH THE PRODUCT AS FOLLOWS:
Do not attempt to modify or use the AC power cord(s) if
they are not the exact type required to fit into the grounded
electrical outlets.
The power cord(s) must meet the following criteria:
The power cord must have an electrical rating that is greater
than that of the electrical current rating marked on the prod-
uct.
THE POWER CORD MUST HAVE SAFETY GROUND PIN OR CONTACT
THAT IS SUITABLE FOR THE ELECTRICAL OUTLET.
THE POWER SUPPLY CORD(S) IS / ARE THE MAIN DISCONNECT
DEVICE TO AC POWER. THE SOCKET OUTLET(S) MUST BE NEAR
THE EQUIPMENT AND READILY ACCESSIBLE FOR DISCONNECTION.
THE POWER SUPPLY CORD(S) MUST BE PLUGGED INTO SOCKET-
OUTLET(S) THAT IS /ARE PROVIDED WITH A SUITABLE EARTH
GROUND.
!
!
!
!
TO AVOID PERSONAL INJURY OR PROPERTY DAMAGE, THE FOL-
LOWING SAFETY INSTRUCTIONS APPLY WHENEVER ACCESSING
THE INSIDE OF THE PRODUCT:
Turn off all peripheral devices connected to this product.
Turn off the system by pressing the power button to off.
Disconnect the AC power by unplugging all AC power
cords from the system or wall outlet.
Disconnect all cables and telecommunication lines that are
connected to the system.
Retain all screws or other fasteners when removing
access cover(s). Upon completion of accessing inside the
product, refasten access cover with original screws or fas-
teners.
Do not access the inside of the power supply. There are no
serviceable parts in the power supply. Return to manufac-
turer for servicing.
Power down the server and disconnect all power cords
before adding or replacing any non hot-plug component.
When replacing a hot-plug power supply, unplug the power
cord to the power supply being replaced before removing the
power supply from the server.
IF THE SERVER HAS BEEN RUNNING, ANY INSTALLED PROCES-
SOR(S) AND HEAT SINK(S) MAY BE HOT.
!
!
To Next Page
Loading...
Need help?
General