SAFETY INFORMATION EQUIPMENT HANDLING PRACTICES
9-3
Equipment Handling Practices
Reduce the risk of personal injury or equipment damage:
Conform to local occupational health and safety require-
ments when moving and lifting equipment.
Use mechanical assistance or other suitable assistance
when moving and lifting equipment.
To reduce the weight for easier handling, remove any eas-
ily detachable components.
Power and Electrical Warnings
THE POWER BUTTON, INDICATED BY THE STAND-BY POWER MARK-
ING, DOES NOT COMPLETELY TURN OFF THE SYSTEM AC
POWER, 5V STANDBY POWER IS ACTIVE WHENEVER THE SYSTEM
IS PLUGGED IN. TO REMOVE POWER FROM SYSTEM, YOU MUST
UNPLUG THE AC POWER CORD FROM THE WALL OUTLET. YOUR
SYSTEM MAY USE MORE THAN ONE AC POWER CORD. MAKE SURE
ALL AC POWER CORDS ARE UNPLUGGED. MAKE SURE THE AC
POWER CORD(S) IS / ARE UNPLUGGED BEFORE YOU OPEN THE
CHASSIS, OR ADD OR REMOVE ANY NON HOT-PLUG COMPONENTS.
DO NOT ATTEMPT TO MODIFY OR USE AN AC POWER CORD IF IT IS
NOT THE EXACT TYPE REQUIRED. A SEPARATE AC CORD IS
REQUIRED FOR EACH SYSTEM POWER SUPPLY.
!
!
SOME POWER SUPPLIES IN SERVERS USE NEUTRAL POLE FUS-
ING. TO AVOID RISK OF SHOCK USE CAUTION WHEN WORKING
WITH POWER SUPPLIES THAT USE NEUTRAL POLE FUSING.
SOME POWER SUPPLIES IN SERVERS USE NEUTRAL POLE FUS-
ING. TO AVOID RISK OF SHOCK USE CAUTION WHEN WORKING
WITH POWER SUPPLIES THAT USE NEUTRAL POLE FUSING.
THE POWER SUPPLY IN THIS PRODUCT CONTAINS NO USER-SER-
VICEABLE PARTS. DO NOT OPEN THE POWER SUPPLY. HAZARD-
OUS VOLTAGE, CURRENT AND ENERGY LEVELS ARE PRESENT
INSIDE THE POWER SUPPLY. RETURN TO MANUFACTURER FOR
SERVICING.
WHEN REPLACING A HOT-PLUG POWER SUPPLY, UNPLUG THE
POWER CORD TO THE POWER SUPPLY BEING REPLACED BEFORE
REMOVING IT FROM THE SERVER.
TO AVOID RISK OF ELECTRIC SHOCK, TURN OFF THE SERVER AND
DISCONNECT THE POWER CORD, TELECOMMUNICATIONS SYS-
TEMS, NETWORKS, AND MODEMS ATTACHED TO THE SERVER
BEFORE OPENING IT.
!
!
!
!
!
To Next Page
Loading...
Need help?
General