CHAPTER TITLE WEB GRAPHICAL USER INTERFACE (GUI) FOR ESMS
4-47
SSL
The Secure Socket Layer protocol was created by Netscape to
ensure secure transactions between web servers and brows-
ers. The protocol uses a third party, a Certificate Authority (CA),
to identify one end or both end of the transactions.
Using MegaRAC GUI, configure SSL certificate into the BMC.
Using this, the device can be accessed in a secured mode.
To open SSL Certificate Configuration page, click Configura-
tion > SSL from the main menu. There are three tabs on this
page.
Upload SSL option is used to upload the certificate and
private key file into the BMC.
Generate SSL option is used to generate the SSL certifi-
cate based on configuration details.
View SSL option is used to view the uploaded SSL certifi-
cate in readable format.
A sample screenshot of SSL Management Page is shown in the
screenshot below.
Figure 4-37. SSL Certificate Configuration – Upload SSL
The fields of SSL Certificate Configuration – Upload SSL tab
are explained below.
Table 4-31: SOL Settings Page
I
TEM DESCRIPTION
Enable Serial over
LAN
Checked=Enabled; Unchecked=Disabled.
Channel Privilege
Level Limit
Select the IPMI Serial over LAN minimum user
privilege:
Administrator
Operator
User
Save Use this button to save your settings.
Advanced SOL
Settings
Use this button to go to advanced SOL page.
Table 4-32: SSL Certificate Configuration - Upload SSL
I
TEM DESCRIPTION
Current Certificate
Current certificate information will be displayed
(read-only).
New Certificate Certificate file should be of pem type
Current Privacy Key
Current privacy key information will be displayed
(read-only).
To Next Page
Loading...
Need help?
General