2.8.2 Mounting Back‐to‐Back MultiSector Integrated Units
When working with MulSector Integrated units, you may wish to increase the coverage to 360o. One of
the ways of doing this is by using a MulSector antenna. Coverage with one MulSector Base Staon
Integrated (view from above):
Figure 58: MulSector Integrated coverage: one unit
Coverage with a MulSector Base Staon Integrated connected with a MulSector antenna (view from
above):
Figure 59: MulSector coverage: with MulSector antenna
The recommended method is to mount a MulSector Base Staon Integrated back‐to‐back with a
MulSector antenna. Do this as follows:
To Next Page
Loading...
