Radwin 5000

RADWIN 5000 Installaon Guide
August 2023
73
2. Alternavely, you can use the SFP connecon, which provides management and data connecon only
(no power). It is labeled “LAN” on the unit, and is referred to as “SFP” in the Web user interface. Note
that you must sll connect a CAT‐5e cable to “PoE In” to provide power:
Figure 93: Data port: MulSector Base Staon
2.14.4 MultiSector Base Station Connectorized
1. Connect a CAT‐5e cable to the “PoE” port of the radio as shown. This connecon provides power to the
unit and can also serve as a management and data connecon. It is referred to as “LAN1” in the Web
user interface.
Figure 94: Input power and data port: MulSector Base Staon Connectorized
2. Alternavely, you can use the SFP connecon, which provides management and data connecon only
(no power). It is labeled “LAN” on the unit, and is referred to as “SFP” in the Web user interface. Note
that you must sll connect a CAT‐5e cable to “PoE” to provide power: