No. Message in display Meaning and possible cause
20 Error at LIN bus participant: Communication problem
• Defective cable
• Loose plug connector
21 Spreader overloaded! For weighing spreader only: The mineral
fertilizer spreader is overloaded.
• Too much fertilizer in the hopper
23 Error by setting TELIMAT The TELIMAT adjustment cannot reach the
specified target value.
• Blockage
• No position feedback
24 Defect by setting TELIMAT Defective TELIMAT actuator
25 Activate disc start. Confirm with ENTER
32 Externally controlled parts can be moved.Risk
of injury through squeezing and shearing! -
Direct ALL persons out of the danger zone -
Read the instruction manual Confirm with
ENTER
If the machine control unit is activated,
components may move unexpectedly.
• Follow the displayed instructions only if all
risks have been eliminated.
36 Weighing quantity impossible. Machine must
stop.
Alarm message during weighing
• The Weigh quantity function can only be
carried out if the machine is at a standstill
and in a horizontal position.
45 Error at M-EMC sensors. EMC control
deactivated!
The sensor has stopped sending signals.
• Cable breakage
• Defective sensor
46 Spreading speed error. Observe spreading
speed of 450..650 rpm!
The PTO speed is outside the range for the
M EMC function.
47 Left dosing error, hopper empty, outflow
blocked!
• Hopper empty
• Outlet blocked
48 Right dosing error, hopper empty, outflow
blocked!
• Hopper empty
• Outlet blocked
49 Idle meas. implausible. EMC control
deactivated!
• Defective sensor
• Defective transmission
6. Alarm messages and possible causes
104
5902662 QUANTRON-A AXIS/MDS
To Next Page
Loading...
Need help?
General
