CHAPTER
3
P/N 016-0171-584 Rev. D 11
CHAPTER 3
SYSTEM CALIBRATION
INITIAL START UP AND CALIBRATION WIZARD
The calibration wizard must be completed the first time that the Hawkeye system is powered up on the ISOBUS
network or if the default system settings are reset. The calibration wizard allows the operator to quickly configure
the required Hawkeye system and nozzle control valves detected by the Hawkeye (Product Controller II) ECU.
Review the following sections for assistance with completing the calibration wizard for the Hawkeye nozzle control
system.
NOTE: Refer to the VT Operation Manual for other necessary setup or calibration required before operating
the Hawkeye nozzle control system or features.
CALIBRATION WIZARD
To access the Hawkeye calibration wizard during the initial system start up:
1. Turn power on to the VT and allow the display to power up and initiate the ISOBUS system.
NOTE: If properly connected and powered, the VT will automatically detect the Hawkeye ECU.
If the ECU is not detected by the display terminal, troubleshoot the Hawkeye ECU and restart the
system. Refer to“Troubleshooting” on page 61 for assistance with connection issues. Contact a local
Raven dealer for additional troubleshooting assistance if the ECU is still not detected.
2. Once the Hawkeye ECU is detected, the Hawkeye Menu button will display in the VT Menu.
3. Touch the Hawkeye Menu button to access the Hawkeye nozzle control system user interface.
4. The first time that the Hawkeye system is started on the VT, or if the default settings have been reset, the first
calibration wizard prompt will be displayed.
NOZZLE SETUP, SPACING, AND TIP SIZE
The following steps are intended to assist with entering the nozzle calibration information required for the
Hawkeye system.
To Next Page
Loading...
