P/N 016-0171-584 Rev. D 63
TROUBLESHOOTING
DIAGNOSTIC TROUBLE CODE (DTC) LIST
The following trouble codes may be displayed by the Hawkeye nozzle control system and should help the
operator to identify and correct issues with system during field operations:.
Code ID Description Recommended Actions
10 .13 VT display is not on-line
1. If this error occurs frequently, check the
ISOBUS connections and review the VT
display troubleshooting procedures.
2. Connect the Raven Service Tool to the
ISOBUS and verify communication.
3. Verify power to Product Controller II ECU.
630
.13 System calibration required
1. Complete the calibration wizard to configure
all required Hawkeye system settings. Refer to
Chapter 3, System Calibration for additional
assistance with the calibration wizard.
.31 Nozzle Calibration Error
1. Complete the calibration wizard to configure
all required Hawkeye system settings. Refer to
Chapter 3, System Calibration for additional
assistance with the calibration wizard.
2. Cycle system power and reset defaults.
1563
.2
Nozzle control valves
incompatible with product
controller/Hawkeye ECU
1. Check for product controller ECU software
updates.
2. Check for nozzle control valve software
updates.
3. Cycle system power and reset defaults.
.31
Inconsistent nozzle control valve
software version
1. Update nozzle control valves to a consistent
software version. Refer to the Raven Service
Tool Operation manual for assistance with the
nozzle update procedure.
To Next Page
Loading...
