4
P/N 016-0171-584 Rev. D 33
HAWKEYE™ NOZZLE CONTROL AND SIDEKICK PRO ICD SETUP
Refer to the Activate the Hawkeye Section Override Feature section on page 52 for assistance with enabling the
section override using an optional Raven ISO Switch Box or the on-screen override button.
SPEED CAL
Enter the Speed Cal value of the radar speed sensor (if equipped). Refer to the radar manufacturer’s specification
for recommended value and perform distance calibration to ensure accuracy.
IMPLEMENT SWITCH
The implement switch senses the position of the toolbar and turns application off when raised and enables
application when lowered.
SYSTEM SETTINGS TAB - TANK FILL
To a cces s the Ta nk Fill Settings menu for an injection product or the main Hawkeye product:
1. Open the VT Menu and select the Hawkeye Menu button.
2. From the home screen, select the Tools Menu softkey along the right side of the display.
3. Select the System Settings tab along the top of the display.
4. Select the Tank Fill Settings button. The following information will be available:
NOTE: The tank fill prompt is also accessible by selecting the tank indicator on the Hawkeye lower home
screen.
5. Select the Product tab that corresponds to the product being edited.
FULL REFILL BUTTON
Select to reset the current tank volume to the configured tank capacity. Use this button
to quickly reset the tank volume when refilling tanks during field operation.
TANK CAPACITY
Enter the maximum tank capacity. Using the tank capacity and current tank level
values, the tank indicator on the lower home screen will display the level of product
remaining for the current application.
NOTE: Tank capacity value cannot be changed while in an application job.
• Full Refill Button • Tank Capacity
• Tank Level • Low Tank Limit
• Fill Meter Calibration Value and Units • Max Tank Fill PWM
Hawkeye
Menu
Tools Menu
System
Settings
Tank Fill
Settings
VT Menu
Tank Fill
Settings
Select
Product
To Next Page
Loading...
