33
Heating up the setting temperature
Move the printing plate down by a few centimetres with the arrow
button "down" (3).
Then push OK.
Use the direction buttons (1) to navigate to menu item "Extruder".
Push OK. Push OK again to select "Temp. Bed".
Set the temperature for the printing plate with the direction buttons.
Since the distance is to be set at printing temperature, set PLA to
"60 °C" and ABS to "120 °C".
Push OK.
Use the direction buttons to select "Temp. 0". Push OK.
Set the temperature for the left extruder with the direction buttons.
Since the distance is to be set at printing temperature, set PLA to
"230 °C" and ABS to "260 °C".
Push OK.
To Next Page
Loading...
