Ricoh A-C4 - Page 102

PM TABLE 20 June 2005
2-2
B195/B198/B264/B265 EM 150K 300K 450K NOTE
DEVELOPMENT UNIT
Development Drive
Gears
I I I
Development Filter R R R
Developer I R I
Entrance Seal I I I
Side Seal I I I
Development Roller C C C Dry cloth
PAPER FEED
Registration Roller C C C C Water or alcohol.
Idle Roller Dust Blade
C C C
Detach and tap gently on flat
surface to empty. Blower
brush.
Registration Roller Dust
Blade
C R C
Blower brush.
Paper Feed Guides C C C Water or alcohol.
Relay Rollers C C C Water or alcohol.
Bottom Plate Pad C C C Water or alcohol.
Bottom Plate Pad (By-
pass feed)
C C C
Water or alcohol.
Registration Sensor C C C Blower brush
Paper Feed Roller Gear
L L L
Silicone Grease G-501. See
note below.*
1
Upper Relay Sensor C C C Blower Brush
DUPLEX UNIT
Upper Transport Roller C C C Water or alcohol.
Lower Transport Roller C C C Water or alcohol.
TRANSFER BELT UNIT
Transfer Belt C R R R
Transfer Belt Cleaning
Blade
R R R
Dry cloth.
To prevent damage to the
cleaning blade, always
replace these items
together.
Transfer Belt Rollers C C C Dry cloth
Entrance Seal C C C Dry cloth
Transfer Entrance
Guide
C C C C
Dry cloth
Used Toner Tank I C C C Empty the tank.
Note: Due to their durability and extended service life, the feed rollers, separation rollers, and
pick-up rollers of the mainframe, optional paper trays, and LCT have been removed from the
PM parts list.