20 June 2005 SCANNER ACCESSIBILITY OPTION (B815)
1-77
Installation
1.20.2 INSTALLATION
This option should be pre-installed at the service center or factory and the final
installation should be done at the work site.
Pre-installation (pp. 73-78)
• Remove Short Scanner I/F Cable
• Connect the Long Scanner Cable to the Copier
• Install Anti-Static Springs on the Operation Panel
• Replace the Board Shield Plates
On-Site Installation(pp. 79-82)
• Move the Scanner Unit to Its Accessible Location
• Remove the Horizontal Arm
• Connect the Long Scanner I/F Cable to the Copier
• Replace the Front Rubber Feet with the Adjustment Screws
• Connect the Scanner
To Next Page