Ricoh A-C4 - Page 219

SERVICE CALL CONDITIONS 20 June 2005
4-18
Pattern Error Status Possible Cause
1-13-2
After the shutter guide motor turns on to
return the shutter guide to its home
position, the shutter guide HP sensor
does not activate within 1s.
sensor defective
1-14-1
After the booklet jogger motor turns on
to move the booklet jogger plate from
its home position, the booklet jogger HP
sensor does not deactivate within 0.5s.
1-14-2
Booklet jogger
motor
After the booklet jogger motor turns on
to return the booklet jogger plate to its
home position, the booklet jogger HP
sensor does not activate within 1s.
• Booklet jogger
motor defective
• Booklet jogger HP
sensor defective
1-15-1
The front staple hammer HP switch
does not turn off within 0.5s after the
front stapler motor turns on.
1-15-2
Front stapler
motor
The front staple hammer HP switch
does not turn on within 0.5s after the
front stapler motor turns on during jam
recovery.
• Front stapler motor
defective
• Front staple
hammer HP
switch defective
•
1-16-1
The rear staple hammer HP switch
does not turn off within 0.5s after the
rear stapler motor turns on.
1-16-2
Rear stapler
motor
The rear staple hammer HP switch
does not turn on within 0.5s after the
rear stapler motor turns on during jam
recovery.
• Rear stapler motor
defective
• Rear staple
hammer HP
switch defective
1-17-1
After the folder plate motor turns on to
return the folder plate to its home
position, the folder plate HP sensor
does not activate within 0.3s.
1-17-2
After the folder plate motor turns on to
move the folder plate from its home
position, the folder plate HP sensor
does not deactivate within 0.3s.
1-17-3
After the folder plate motor turns on to
return the folder plate to its home
position, the folder plate return sensor
does not deactivate within 0.3s.
1-17-4
Folder plate
motor error
The pulse count from the folder plate
motor sensor is lower than the target
minimum.
• Folder plate motor
defective
• Folder plate HP
sensor defective
• Folder plate return
sensor defective
• Folder plate motor
sensor defective
1-18-1
The connector of the shutter guide HP
sensor is not connected.
1-18-2
Connector
The connector of the folder plate HP
sensor is not connected.
• Poor connection or
no connection of
the shutter guide
HP sensor
t