20 June 2005 SERVICE PROGRAM MODE TABLES
5-75
Service
Tables
Sheet Through Magnification [–50.0 ~ +50.0 / 0.0 / 0.1%/step] 6017*
Adjusts the magnification in the sub-scan direction for ADF mode.
Use the key to toggle between + and - before entering the value
Staple Position Adjustment [–3.5~+3.5 / 0.0 / 0.5 mm step] 6105*
Adjusts the staple position in the main scan direction when using the two-tray
finisher.
Press
to toggle
±
. A larger value shifts the staple toward the edge of the paper.
Punch Hole Adjustment 6113*
Adjusts the punch hole position.
SP6113 1: 2-hole punches for Japan, North America, Europe, and 4-hole punches
for Northern Europe.
SP6113 2: 3-hole punches for North America, and 4-hole punches for Europe.
Press
to toggle
±
. A larger value shifts the holes toward the edge of the paper.
6113 1* 2-Holes [–7~+7 / 0 / 0.5 mm steps]
6113 2* 3-Holes [–7~+7 / 0 / 0.5 mm steps]
Fold Position Adjustment 6902*
Allows fine adjustment of the fold position on paper when the Booklet Finisher is
connected and used.
6902 1* A3/DLT [-30~+30 / 0 / 0.5 mm]
6902 2* B4 [-20~+20 / 0 / 0.5 mm]
6902 3* A4/LT [-15~+15 / 0 / 0.5 mm]
To Next Page
Loading...
