Ricoh A-C4 - Page 35

PAPER TRAY UNIT INSTALLATION (B542) 20 June 2005
1-22
4. Remove the middle front cover [A] and pull out the front handles [B].
5. Using the front handles and rear handles, lift the machine and hold it over the
paper tray unit [C].
6. Slowly lower the machine onto the paper tray unit with the pegs [D] aligned with
the peg holes on the bottom of the machine.
NOTE: Do not hold the scanner unit.
7. Re-install the middle front cover [A].
8. Attach the spring washer [E] to the short knob screw [F]. Then, secure the
paper tray unit.
9. Open the right cover of the paper tray unit [G].
10. Secure the joint bracket [H] (1 long knob screw).
11. Remove the connector cover [I] of the main machine ( x 1).
12. Connect the paper tray unit harness [J] to the main machine and reinstall the
connector cover.
B542I513.WMF
B542I517.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]
[H]
[I]
[J]