20 June 2005 SCANNER ACCESSIBILITY OPTION (B815)
1-79
Installation
4. Remove:
[A]: Lens block cover ( x4)
[B]: Lens block assembly ( x4)
[C]: Disconnect flat-film connector from
the lens block.
5. Disconnect:
[D]: Original length sensor ( x1)
• Push the sensor forward toward the
front. It is not necessary to
disconnect or remove the sensor.
[E]: Ground wire [E] ( x1)
[F]: Short scanner I/F cable ( x2).
6. Remove the rear cover [G]
( x5, x1)
7. Remove the connector cap [H] and
disconnect the short scanner I/F cable
[I] from the mainframe (x1, x1).
8. Pull the short scanner I/F cable out of
the scanner unit.
B815I102.WMF
B815I104.WMF
B815I105.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]
[H]
[]
To Next Page
Loading...
