9 March 2004 SERVICE PROGRAM
5-65
Service
Tables
5.1.7 OUTPUT CHECK (SP5-804)
Conducting Output Check
CAUTION:
To prevent mechanical or electrical damage, do not keep an electrical
component on for a long time.
1. Select SP5-804.
2. Select the number (see the table below) corresponding to the component.
3. Select “ON.”
4. To stop the operation, select “OFF.”
Output Check Table
Num. Component
001 Main Motor Forward
002 Main Motor Reverse
003 Quenching Lamp
004 Toner Supply Clutch Forward
005 Fan Motor High
006 Fan Motor Low
007 Registration Clutch
008 By-pass Feed Clutch
009 Upper Feed Clutch
010 Lower Feed Clutch
017 BK-Lift Motor
020 Duplex Inv Motor Reverse
021 Duplex Inv Motor Forward
024 Duplex Inv Motor Hold
026 Polygon Motor
027 Polygon M/LD
028 LD
029 DF-Transport Motor
031 DF-Feed Clutch
038 Fusing Solenoid
039 Fast Dup Inv M-Rev
When checking Fan Motor High (005) or Fan Motor Low (006) note the following:
• These motors may not respond when the fusing temperature is high.
•
Selecting “ON” checks that one of these motors normally operates. Selecting
“OFF” turns off the motor that you have started by selecting “ON.” However, this
does not guarantee that the motor normally stops during normal operation.
To Next Page
Loading...
