Ricoh Aficio 1515 - Sp Mode Tables-Basic Model; SP1-XXX (Feed)

9 March 2004 SERVICE PROGRAM
5-3
Service
Tables
5.1.2 SP MODE TABLES–BASIC MODEL
The tables in this section (5.1.2) list the service programs (SPs) that are available
when the controller box is NOT installed. For the SPs that are available with the
controller box, see the next section (5.1.3).
Keys in the tables:
• Asterisk (*): The settings are saved in the NVRAM. Most of them return to the
default values when you execute SP5-801-002 (☛5.1.5).
• DFU: The program is for the design/factory use only. Do not change the settings.
•
Brackets ([ ]): The brackets enclose the setting rage, default value, and minimum
step with unit ([Minimum ∼ Maximum / Default / Step]).
SP1-XXX (Feed)
1001*
Leading Edge Registration [–9.0 ~ 9.0 /
0.0
/ 0.1 mm/step]
1001 1 All Trays
1001 2 By-pass
1001 3 Duplex
Adjusts the leading-edge registration (
☛
3.14).
1002*
Side-to-Side Registration [–9.0 ~ 9.0 /
0.0
/ 0.1 mm/step]
1002 1 1st Tray
1002 2 Optional Tray
1002 5 By-pass
Adjusts the side-to-side registration (
☛
3.14). SP1-
002-001 is applied to all trays. SP1-002-002 and
005 adjusts the difference from SP1-002-001.
1002 6 Duplex
Adjusts the side-to-side registration of the 2nd side
in duplex copying. The 1st side is adjusted by SP1-
002-001 through 005.
1003*
Paper Feed Timing
Adjusts the amount of paper buckle on the
registration roller.
1003 1 1st tray [0 ~ 10 /
5
/ 1 mm/step]
1003 3 Optional tray [0 ~ 10 /
5
/ 1 mm/step]
1003 4 By-pass feed [0 ~ 10 /
5
/ 1 mm/step]
1003 5 Duplex [0 ~ 20 / 5 / 1 mm/step]
1103*
Fusing Idling [
0
= No / 1 = Yes]
1103 1 Enables or disables the contact-release control. The table below lists the results.
Setting 0 = No 1 = Yes
C-R control Works Does not work
Idling time Shorter Longer
Fusing quality Lower Higher