9 March 2004 FIRMWARE UPDATE PROCEDURE
5-77
Service
Tables
Downloading SD Card Data
You can copy the data from an SD card to the NVRAM.
1. Turn off the main power switch of the copier.
2. Insert the SD card into the lower slot. Make sure that the SD card is correctly
set.
3. Turn on the main power switch of the copier.
4. Activate the SP mode.
5. Select SP5-825-001 (NVRAM Download).
6. Press the Execute key. The copier starts downloading.
When an error occurs, take the following actions:
1. Check the serial number of the data. You can find the serial number in the file
name of the data (
☛
2. Uploading NVRAM Data).
3. Retry the download procedure.
4. If downloading does not normally end, manually specify settings. See the SMC
report for the settings.
To Next Page
Loading...
