FIRMWARE UPDATE PROCEDURE 9 March 2004
5-72
5.2 FIRMWARE UPDATE PROCEDURE
This section (5.2) illustrates how to update the firmware of the machines with the
controller box. To update the firmware of the basic model (the machine without the
controller box), see section 5.1.10.
To update the firmware, you must download the new version of the firmware to an
SD Card (Secure Digital Card). You insert the SD Card into the lower slot on the
side of the controller box.
5.2.1 HANDLING SD CARD
An SD card is a precision device. Use extreme caution:
•
Turn off the main power switch before inserting an SD card. Do not insert an SD
card into the slot with the power on.
• After turning on the main power switch, do not remove the SD card from the slot.
• Do not turn off the power switch while the data is downloaded.
• Keep SD cards in a safe place. Do not expose SD cards to high temperature,
high humidity, or direct sunlight.
•
Do not bend or scratch an SD card. Do not drop an SD card or expose it to other
shock or vibration.
5.2.2 FIRMWARE UPDATE PROCEDURE
1. Turn off the main power switch.
2. Physically disconnect the copier from
the network. This prevents jobs from
coming into the copier during firmware
update.
3. Remove the slot cover [A] (
%
x 1)
4. Turn the label on the SD card [B] to the
rear side of the copier, and insert the
SD card into the lower slot [C]. Slowly
push the SD card into the slot so it
locks in place.
5. Make sure the SD card is locked in
place.
NOTE: To remove the SD card, push it
in to unlock it.
6. Turn the main power switch on. After about 10 seconds, the initial version
update screen appears on the LCD.
B130S902.WMF
[C]
[A]
[B]
To Next Page
Loading...
