9 March 2004 ADJUSTING COPY IMAGE AREA
3-35
Replacement
Adjustment
3.14 ADJUSTING COPY IMAGE AREA
Adjust the copy image area under any of the following conditions:
• You have cleared engine data (SP5-801-002 or SP5-998-001).
•
You have replaced any of the following components:
• First scanner or second scanner
• Lens block
•
Scanner motor
•
Polygon mirror motor
• Paper tray
3.14.1 PRINTING
Make sure that the paper is correctly loaded in each paper tray before starting the
adjustment procedure in this section.
Adjusting Registration
Use the Trimming Area Pattern (SP5-902-001 > 10) for this adjustment.
1. Print out the test pattern with the paper
fed from the regular paper tray.
2. Print out the test pattern with the paper
fed from the by-pass tray.
3. Print out the test pattern by selecting
duplex printing.
4. Measure the distance between the
leading edge of the image area and the
leading edge of the paper [A].
NOTE:
The diagram shows the paper on the copy tray. Note that the paper is
output with the face down.
5. Adjust the leading edge registration
(SP1-001).
6. Measure the distance between the
side edge of the image area and the
side edge of the paper [B].
7. Adjust the side-to-side registration
(SP1-002).
8. Specify "0" (zero) in SP5-902-001
after finishing the adjustment
procedure.
B130R935.WMF
SP Specification
SP1-001-001 (All Trays)
0 ± 2 mm
SP1-001-002 (By-pass)
0 ± 2 mm
SP1-001-003 (Duplex)
0 ± 4 mm
SP Specification
SP1-002-001 (1st tray)
0
±
2 mm
SP1-002-002 (2nd tray)
0
±
2 mm
SP1-002-005 (By-pass)
0
±
4 mm
SP1-002-006 (Duplex)
0 ± 4 mm
[A]
[B]
To Next Page
Loading...
