SERVICE PROGRAM 9 March 2004
5-28
SP4-XXX (Scanner)
4008*
Sub-Scan Magnification (Scanner) [-0.9 ~ +0.9 /
0.0
/ 0.1%/step]
4008 1 Adjusts the sub-scan magnification (☛ 3.14).
4009*
Main Scan Magnification (Scanner) [–0.9 ~ +0.9 /
0.0
/ 0.1%/step]
4009 1 Adjusts the main-scan magnification (☛ 3.14).
4010*
Leading Edge Registration (Scanner) [–5.0 ~ +5.0 /
0.0
/ 0.1 mm/step]
4010 1 Adjusts the leading edge registration (☛ 3.14).
4011*
Side-to-side Registration (Scanner) [–1.0 ~ +1.0 /
0.0
/ 0.1 mm/step]
4011 1 Adjusts the side-to-side registration for scanning in platen mode (
☛
3.14).
4012*
Scan Erase Margin [0 ~ 9.0 /
1.0
/ 0.1 mm/step]
4012 1 Leading edge
4012 2 Trailing edge
4012 3 Left
4012 4 Right
Adjusts the scanning margin. Generally, the
scanning margin should be as little as possible. To
adjust the image area, use SP2-101.
4013
Scanner Free Run
4013 1 Conducts the scanner free run with the exposure lamp on.
4015*
White Plate Scanning
Start position [–3.0 ~ +6.0 / 0.0 / 0.1 mm/step] 4015 1
Adjusts the scanning start position on the white plate. The base value is 17.8 mm
from the scanner home position. This SP specifies the offset from this base value.
Scanning length [–3.0 ~ +6.0 /
0.0
/ 0.1 mm/step] 4015 2
Adjusts the distance of the white plate scan. The scan begins from the start position
(SP4-015-001) and ends at the specified distance. The base value is 2.0 mm. This
SP decides the offset from this base value. Specify 0 (zero) or a larger value.
4428
Scan Auto Adjustment
4428 1
Conducts the automatic scanner adjustment. Use this SP after replacing the white
plate (☛ 3.14.2).
To Next Page
Loading...
