Ricoh Aficio 1515 - Adjusting Blank Margin; Adjusting Main-Scan Magnification

ADJUSTING COPY IMAGE AREA 9 March 2004
3-36
Adjusting Blank Margin
Use the Trimming Area Pattern (SP5-902-001 > 10) for this adjustment.
1. Print out the test pattern.
2. Measure the distance between the four
edges of the image area and the four
edges of the paper [A][B][C][D].
NOTE: The diagram shows the paper
on the copy tray. Note that the
paper is output with the face
down.
3. Adjust the blank margin (SP2-101).
SP Specification
SP2-101-001 (Leading Edge) [A]
2 ± 1.5 mm
SP2-101-002 (Trailing Edge) [B] 2 +2.5/-1.5 mm
SP2-101-003 (Left Side) [C]
2 ± 1.5 mm
SP2-101-004 (Right Side) [D] 2 +2.5/-1.5 mm
NOTE:
The "Left Side" and "Right Side" comes to your left-hand side and right-
hand side respectively when you view the copied image with the
leading edge upwards.
4. Specify "0" (zero) in SP5-902-001 after finishing the adjustment procedure.
Adjusting Main-Scan Magnification
Use the Grid Pattern (Single Dot) (SP5-902-001 > 5) for this adjustment.
1. Print out the test pattern.
2. Measure the sides of squares. Each side should be 2.7-mm long.)
3. Adjust the main-scan
magnification (SP2-998-001:
Main Mag-print).
4. Specify "0" (zero) in SP5-902-001 after finishing the adjustment procedure.
B130R936.WMF
SP Specification
SP2-998-001 (Main Mag-print)
100 ± 1%
[A]
[B]
[C]
[D]