Ricoh Aficio 1515 - SP5-XXX (Mode)

9 March 2004 SERVICE PROGRAM
5-33
Service
Tables
SP5-XXX (Mode)
5001
All Indicators On
5001 1 Turns on all LEDs.
SSP
5044*
Operation Panel Bit Switch
DFU
5113*
Optional Counter Type
0:
None
5: MF key card (Peace) Japan Only
11: MF key card (Increment)
12: MF key card (Decrement)
5113 1 Selects the corresponding key for installed devices such as coin lock.
5120*
Clear-OP Count Remove [
0
=Yes / 1=Standby only / 2=No]
5120 1
Specifies the condition to reset the copy job settings when the key counter is
removed.
•
0 = Yes: The settings are cleared when the counter is removed.
• 1 = Standby only: The settings are cleared when the counter is removed at the
end of a job.
•
2 = No: The settings are not cleared under either condition.
As for duplex copying, the job settings are always preserved regardless of these
setting.
5121*
Count Up Timing [
0
= Feed In / 1 = Exit]
5121 1 Selects the count-up timing.
• 0 = Feed: At each paper feed
• 1= Exit: At each paper exit
5162*
Application Switching Method [
0
= Soft Key Set / 1 = Hard Key Set]
5162 1
Determines whether the application screen is switched with the hardware switch or
the software switch.
5302* Time
[-1440 ∼ +1440 /
0
/ 1 minute/step]
5302 2 Time Difference Species the time difference from GMT.
5307*
Summer Time
5307 1 On/Off
Validates or invalidates the daylight-saving-time
settings (SP5-307-003 and 004).
5307 3 Start Specifies the start of the daylight saving time.
5307 4 End Specifies the end of the daylight saving time.