Ricoh Aficio 1515 - Firmware Update Procedure for Basic Model

9 March 2004 SERVICE PROGRAM
5-69
Service
Tables
5.1.10 FIRMWARE UPDATE PROCEDURE FOR BASIC MODEL
This section (5.1.10) illustrates how to update the firmware of the basic model (the
machine without the controller box). To update the firmware of the other models
(the machine with the controller box), see section 5.2.
1. Turn the main power switch off.
2. Remove the memory card cover [B]
(
%
x 1).
3. Turn the face of the flash memory card
[A] (“A” is printed on it) to the rear of the
copier, and insert it into the card slot [C].
4. Press down the power switch on the
operation panel and hold it, and turn
on the main power switch.
5. Press the “Execute” key [D]. The
program starts running.
6. Do not touch any key while the
message “Load Status...” is displayed.
This message indicates that the
program is running.
7. Check that the message “End Sum...”
is displayed. This message indicates
that the program has ended normally.
8. Turn off the main power switch.
9. Remove the flash memory card.
10. Attach the memory card cover.
11. Turn the main power switch on, and
check the operation.
B130S901.WMF
B130S904.WMF
B130S905.WMF
B130S906.WMF
COPY
5.827.001 Program Download
Execute
[D]
COPY
5.827.001 Program Download
Load Status:&–&&&&&&&
Execute
COPY(Class3)
5.827.001 Program Download
End Sum:&&&&H 0.20 EXP
[B]
[C]
[A]