9 March 2004 BIT SWITCHES
3-9
Service
Tables
System Switch 02 SP No. 1-101-003
No FUNCTION COMMENTS
0-1 Not used Do not change the settings.
2 Communication stall fail safe.
0: Disabled
1: Enabled
If enabled, the machine cuts communication within
one hour of a communication error but the
connection remains established.
3-4 Not used. Do not change the settings.
5 Not used Do not change the setting.
6
to
7
Memory read/write by RDS
Bit 7 6 Setting
0 0 Always disabled
0 1 User selectable
1 0 User selectable
1 1 Always enabled
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out,
but the user can temporarily switch RDS on to allow
RDS operations to take place. RDS will
automatically be locked out again after a certain
time, which is stored in System Switch 03. Note that
if an RDS operation takes place, RDS will not switch
off until this time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
System Switch 03 SP No. 1-101-004
No FUNCTION COMMENTS
0
to
7
Length of time that RDS is
temporarily switched on when
bits 6 and 7 of System Switch
02 are set to “User selectable”
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System
Switch 02 are set to “User selectable”.
The default setting is 24 hours.
System Switch 04 SP No. 1-101-005
No FUNCTION COMMENTS
0-2
Not used Do not change the settings.
3
Printing dedicated tx
parameters on Quick Dial Lists
0: Disabled
1: Enabled
1: Each Quick dial number on the list is printed with
the dedicated tx parameters (10 bytes each).
The first 10 bytes of data are the programmed
dedicated tx parameters; 34 bytes of data are
printed (the other 24 bytes have no use for service
technicians).
4-7
Not used Do not change the settings.
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06
- Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
To Next Page
Loading...
