9 March 2004 BIT SWITCHES
3-25
Service
Tables
Communication Switch 14 SP No. 1-104-021
No FUNCTION COMMENTS
0 Inch-to-mm conversion during
transmission
0: Disabled 1: Enabled
0:
In immediate transmission, data scanned in inch
format are transmitted without conversion.
In memory transmission, data stored in the SAF
memory in mm format are transmitted without
conversion.
Note: When storing the scanned data into SAF
memory, the fax unit always converts the data into
mm format.
1: The machine converts the scanned data or stored
data in the SAF memory to the format which was
specified in the set-up protocol (DIS/NSF) before
transmission.
1-5
Not used Do not change the factory settings.
6
to
7
Available unit of resolution in
which fax messages are
received
Bit 7 Bit 6 Unit
0 0 mm
0 1 inch
1 0 mm and inch
(default)
1 1 Not used
For the best performance, do not change the factory
settings.
The setting determined by these bits is informed to
the transmitting terminal in the pre-message
protocol exchange (in the DIS/NSF frames).
Communication Switch 15 - Not used (Do not change the settings.)
Communication Switch 16 - Not used (Do not change the settings.)
Communication Switch 17 - Not used (Do not change the settings.)
Communication Switch 18
- Not used (Do not change the settings.)
Communication Switch 19
- Not used (Do not change the settings.)
Communication Switch 1A
- Not used (Do not change the settings.)
Communication Switch 1B SP No. 1-104-028
No FUNCTION COMMENTS
0
to
7
Extension access code (0 to 7)
to turn V.8 protocol On/Off
0: On
1: Off
If the PABX does not support V.8/V.34 protocol
procedure, set this bit to “1” to disable V.8.
Example:
If “0” is the PSTN access code, set bit 0
to 1. When the machine detects “0” as the first
dialed number, it automatically disables V.8
protocol. (Alternatively, if “3” is the PSTN access
code, set bit 3 to 1.)
To Next Page
Loading...
