Copying from the Bypass Tray
41
2
When Copying onto OHP Transparencies
When copying onto OHP transparencies, select the type and size of paper.
Important
❒ We recommend that you use specified OHP transparencies.
❒ OHP transparencies must be loaded face up in the tray with the notched cor-
ner of the sheet in the appropriate corner of the tray.
❒ To prevent multiple sheets from being fed at once, fan paper before placing it
on the tray.
❒ When copying onto OHP transparencies, remove copied sheets one by one.
A Open the bypass tray, and then align the paper guide to the paper size.
B Insert the paper face-up until you hear the beep.
The bypass tray is automatically selected.
C Press the {q} key.
D Select paper type ([OHP (Transparency)]) in the Special Paper settings.
E Select the paper size, and then press [OK] to return to the initial display.
F Place the originals, and then press the {Start} key.
G When the copy job is finished, press the {Clear Modes} key to clear the settings.
Note
❒ For OHP transparencies, print speed is slower when compared to printing
on plain paper.
❒ If you have selected [OHP (Transparency)] in “Special Paper”, you cannot
have copies delivered face down.
To Next Page
Loading...
