002
DFU
Humidity:Threshold:M-humid *ENG [0 to 100 / 1 / 1 %/step]
Specifies the threshold between low and middle humidity.
003
DFU
Humidity:Threshold:H-humid *ENG [0 to 100 / 65 / 1 %/step]
Specifies the threshold between middle and high humidity.
004
DFU
Permit Temp.:Delta:Press:M-
humid
*ENG [0 to 200 / 100 / 1deg/step]
Specifies the threshold temperature for the curl control in middle humidity.
005
DFU
Permit Temp.:Delta:Press:H-
humid
*ENG [0 to 100 / 100 / 1deg/step]
Specifies the threshold temperature for the curl control in high humidity.
008
DFU
CPM:M-humid *ENG [0 to 100 / 80 / 1%/step]
Specifies the CPM ratio of the decurl control against to the normal operation in middle
humidity.
009
DFU
CPM:H-humid *ENG [0 to 100 / 65 / 1%/step]
Specifies the CPM ratio of the decurl control against to the normal operation in high
humidity.
1114
[Heat Storage Status] DFU
Sets the threshold for fusing temperature correction to compensate for heat accumulated
on the pressure roller.
001 Temp.:Threshold:Press *ENG [0 to 200 / 80 / 1 deg/step]
002 Temp.:Threshold:Atmosphere *ENG [0 to 200 / 80 / 1 deg/step]
1122
[Standby Rotation Setting] DFU
Sets the interval between fusing roller idle rotations during standby.
001 Rotation Interval *ENG [0 to 240 / 60 / 1min/step]
002 Rotation Time *ENG [0 to 10000 / 5 / 1msec/step]
Main SP Tables-1
341
To Next Page
Loading...
