5516
[Individual PM Part Alarm Call]
With @Remote in use, these SP codes can be set to issue a PM alarm call when one of SP
parts reaches its yield.
001
Disable/Enable Setting (0:Not
Send,1:Send)
*CTL
[0 or 1 / 1 / - ]
0: Not send, 1: Send
004
Percent yield for triggering PM
alert
*CTL [1 to 255 / 75 / 1 %/step]
5610 [Base Gamma Ctrl Pt:Execute]
004
Get Factory Default *ENG -
Recalls the factory settings.
005
Set Factory Default *ENG -
Overwrites the current values onto the factory settings.
006
Restore Orginal Value *ENG -
Recalls the previous settings.
5611 [Toner Color in 2C]
001
B-C *ENG
[0 to 128 / 100 / 1 /step]
128: Darkest density
Adjusts the Cyan correction value of the blue signal in two-color mode.
002
B-M *ENG
[0 to 128 / 100 / 1 /step]
128: Darkest density
Adjusts the Magenta correction value of the blue signal in two-color mode.
003
G-C *ENG
[0 to 128 / 100 / 1 /step]
128: Darkest density
Adjusts the Cyan correction value of the blue signal in two-color mode.
5. System Maintenance
448
To Next Page
Loading...
