Serial 1 wrap
This test is used to the serial port option card. It only appears if the card is installed in the PCI slot.
To run the SERIAL 1 WRAP Test:
1. Touch to select "Serial 1 Wrap" from HARDWARE TESTS.
The message "Serial 1 Wrap Test Testing…" displays. Then the message "Resetting Printer" appears.
2. The machine automatically performs a Power On Reset (POR). While the CACHE test executes, the
power indicator blinks green. The following type of message appears:
3. To stop this test before completion, turn the machine off.
USB HS test mode
1. Select "USB HS Test Mode" from HARDWARE TESTS.
2. Press until the appears next to the Port to be tested, and then press .
3. Select the desired Test, and then press .
Port Test Appears on the display
Port 0
Test J
Test K
Test SEO NAK
Test Packet
Test Force Enabled
USB High Speed Certification
Testing...
Port 1
Test J
Test K
Test SEO NAK
Test Packet
Test Force Enabled
USB High Speed Certification
Testing...
Port 2
Test J
Test K
Test SEO NAK
Test Packet
Test Force Enabled
USB High Speed Certification
Testing...
Diagnostics Menu
167
To Next Page
Loading...
