User primary message Explanation
Load Manual <size>
The machine does not detect media meeting the description <size> in
the single sheet feeder (manual feeder).
The following actions can be taken:
• Load paper and the job continues.
• Press Select ( ), and choose an alternate source for media.
• Cancel the current job.
Load Manual <type> <size>
The machine does not detect media meeting the description <type>
and <size> in the single sheet feeder (manual feeder).
The following actions can be taken:
• Load paper and the job continues.
•
Press "Select" (
), and choose an alternate source for media.
•
Cancel the current job.
Paper Changes Needed
Change or load new media.
PJL OP Message
PJL Seed Message
PJL ST Message
Try one or more of the following:
• press Select (
) to clear the message, and continue printing.
• Wait for the message to clear.
Remove Paper ADF
This posts when there is paper detected in the ADF upon POR or
when the cover is closed (or any other situation that re-initializes the
scanner). Message clears when paper is removed.
Remove Paper Standard Bin
The standard output bin is full or nearly full. Remove the media from
the bin.
Restore Held Jobs. Go/Stop?
Held jobs were found on disk after a power on/off reset. Restoring
will make these jobs available. Jobs may also be restored at a later
time by turning off and restarting the machine.
The following actions can be taken:
• Restore
• Do not restore
•
More information
6. Troubleshooting
200
To Next Page
Loading...
