Ricoh LI-MF1 M126 - Page 232

Error code Description Action
80D
Received too many requests from remote
end to repeat the previous command sent.
• Check line quality.
• Adjust ‘Transmit Level’.
• Check if line conditions on remote
end will facilitate a good
connection.
80E
Functional limitation- Remote fax device
does not support G3 receive capability.
No action needed. Issue with the
remote device.
811
Failed to detect a fax device at the
remote end.
•
Verify MFD is answering to fax
call and not a voice call.
• Decrease value of ‘Rings To
Answer’ setting.
812
No more data rates available in V34
modulation scheme.
• Adjust to a lower modulation
scheme.
813
Timeout occurred after waiting too long
to receive a good frame.
•
Adjust “Receive Threshold”.
814
Tried too many times at selected speed
using V34 modulation scheme.
• Adjust ‘Transmit Level’.
• Adjust to a lower modulation
scheme.
815
Fax transmission was interrupted due to
power failure.
Troubleshoot the machine if error
persists. See “Modem / Fax Card
Service Check” in “Troubleshooting”.
818
Fax transmission failed due to insufficient
memory to store scanned image.
Adjust ‘Memory Use’ setting to
allocate more memory for send jobs.
819
Fax transmission failed due to insufficient
memory to store received image.
Adjust ‘Memory Use’ setting to
allocate more memory for receive jobs.
81A
A timeout occurred during transmission of
a page in ECM mode.
Select a lower ‘Max Speed’ value
under Fax Send settings.
880
Failure to transmit training successfully in
V17, V29, V27 terminal modulation
schemes.
• Select a lower “Max Speed”
under Fax Send settings.
• Adjust the “Transmit Level”.
• Check line quality.
6. Troubleshooting
230
6