Ricoh LI-MF1 M126 - Page 234

Error code Description Action
889
Failed to connect at the minimum speed
supported by the machine.
• Adjust “Transmit Level”.
• Incompatible connection.
88A
Failed to connect using V.34 modulation
scheme.
Check line quality.
Adjust to a lower modulation scheme.
Adjust Transmit Level Receive
Threshold values.
901 No fax tones detected from remote end.
• Verify destination phone number.
• Verify that the remote fax is
authorized to receive faxes.
902 No dial tone detected.
• Check by enabling ‘Behind a
PABX’ setting.
• Check phone line.
• Check MFD modem hardware.
903 Busy tone detected.
Check with remote end if successive
attempts fail.
904 Hardware error detected.
See “Modem / Fax Card Service
Check” in “Troubleshooting”.
905
A timeout occurred after dialing the
number and waiting for a response.
Check with remote end if successive
attempts fail.
906 Fax cancelled by user. No action needed.
907
Modem detected a digital line
connection.
Verify the machine is connected to an
analog line. See “Fax Transmission
Service Check” in “Troubleshooting”.
908 Phone line was disconnected Restore phone line connection.
A00
Received request for unsupported
function from remote fax device.
No action needed.
A01
Received request for unsupported image
width from remote fax device.
No action needed.
A02
Received request for unsupported image
resolution from remote fax device.
No action needed.
6. Troubleshooting
232
6