Ricoh M065 - Page 414

System Service Mode
M065/M066 8-4 SM Appendix
022 Duplex:Plain:1200dpi *ENG
[–20 to 20 / -2 / 1 mm/step]
023 Duplex:M-Thick:1200dpi *ENG
[–20 to 20 / -2 / 1 mm/step]
024 Duplex:Thick1:1200dpi *ENG
[–20 to 20 / -4 / 1 mm/step]
1103 [Fusing Idling] Fusing Idling Adjustment
012 Forced Idling Stop *ENG
[0 to 1 / 0 / 1 /step]
013 Forced Idling Stop Temp. *ENG
[100 to 180 / 100 / 1 deg/step]
014 Minimum Idling Time *ENG
[0 to 10 / 2 / 1 sec/step]
016 to
018
Specifies how long the extra idling operation is executed for each
environment.
Each environment is determined with SP1112-001 and 002.
016 Extra Idling Time (L) *ENG
[0 to 60 / 20 / 1 sec/step]
017 Extra Idling Time (H) *ENG
[0 to 60 / 0 / 1 sec/step]
018 Extra Idling Time (M) *ENG
[0 to 60 / 0 / 1 sec/step]
019 Ex Idling Temp:P-Roll *ENG
[0 to 160 / 110 / 1 deg/step]
020 Control Switch Temp *ENG
[0 to 15 / 16 / 1 deg/step]
1104 [Fusing Idling Before Job]
001 Environment Thresh *ENG
[0 to 2 / 2 / 1 /step]
002
Idling Temp:P-Roll *ENG
[0 to 160 / 160 / 1 deg /step]
Specifies the threshold temperature for the pressure roller idling before a job.
003 Idling Time: BW *ENG
Specifies the fusing idling time
for each printe mode before a
job.
[0 to 10 / 2 / 1 sec/step]
004 Idling Time: FC *ENG
005 Idling Time: M-Thick: BW *ENG
006 Idling Time: M-Thick: FC *ENG
007-009 Specifies the thereshold temperature of the paper feed before a job.