Ricoh M281 Series - Page 522

Service Call 816-899
D255/D256/M281/M282 6-84 SM
No. Type Error Name/Error Condition/Major Cause/Solution
SC874-61
to -65
D Delete all error (Delete data area) : library error
SC874-66 D Delete all error (Delete data area) : Unavailable
SC874-67 D Delete all error (Delete data area) : Erasing not finished
SC874-68 D Delete all error (Delete data area) : HDD format failure (Normal)
SC874-69 D Delete all error (Delete data area) : HDD format failure
(Abnormal)
SC874-70 D Delete all error (Delete data area) : Unauthorized library (MP
501/601 Only)
SC874-99 D Delete all error (Delete data area) : other errors
An error occurred while data was being erased on HDD or
NVRAM.
 Error detected in HDD data delete program
 Error detected in NVRAM data delete program
 The "Delete All" option was not set
 Turn the main power OFF and back on, and then execute
"Erase All Memory" under UP mode again. (However, if there
is a defective sector or other problem with the hard disk, the
error will persist even after trying the above.)
 If the "Delete All" option is not installed when this error
occurs, install the option.