Ricoh M281 Series - Page 752

Main SP Tables-8
D255/D256/M281/M282 3-112 SM Appendix
8215 S:Scan PGS/LS *CTL stored from within the document server mode
screen at the operation panel, and with the
Store File button from within the Copy mode
screen.
8216 L:Scan PGS/LS *CTL
 Reading user stamp data is not counted.
 If a job is cancelled, the pages output as far as the cancellation are counted.
 If the scanner application scans and stores 3 B5 sheets and 1 A4 sheet, the S: count is 4.
 If pages are copied but not stored on the document server, these counters do not change.
 If both sides of 3 A4 sheets are copied and stored to the document server, the C: count is 6
and the L: count is 6.
 If you enter document server mode then scan 6 pages, the L: count is 6.
8221 ADF Org Feeds *CTL [0 to 99999999/ 0 / 1/step]
These SPs count the number of pages fed through the ADF for front and back
side scanning.
001 Front
Number of front sides fed for scanning:
With an ADF that can scan both sides simultaneously, the Front side count is
the same as the number of pages fed for either simplex or duplex scanning.
With an ADF that cannot scan both sides simultaneously, the Front side count
is the same as the number of pages fed for duplex front side scanning. (The
front side is determined by which side the user loads face up.)
002 Back
Number of rear sides fed for scanning:
With an ADF that can scan both sides simultaneously, the Back count is the
same as the number of pages fed for duplex scanning.
With an ADF that cannot scan both sides simultaneously, the Back count is the
same as the number of pages fed for duplex rear-side scanning.
 When 1 sheet is fed for duplex scanning the Front count is 1 and the Back count is 1.
 If a jam occurs during the job, recovery processing is not counted to avoid double counting.
Also, the pages are not counted if the jam occurs before the first sheet is output.