Ricoh M281 Series - Page 858

Error Codes
D255/D256 FAX OPTION 24 SM
Code Meaning Suggested Cause/Action
0-07
No post-message response
from the other party after a
page was sent
 Check the connection.
 Replace the FCU.
 The other party is out of paper or has a
paper jam.
 The other party may have disconnected
the call.
 Check for a bad line.
 The other machine may be defective. Try
sending to another machine.
0-08
The other party sent RTN or
PIN after receiving a page,
because there were too many
errors
 Check the connection.
 Replace the FCU.
 The other party may have a paper jam, or
run out of paper or memory space.
 Try adjusting the TX level and/or cable
equalizer settings.
 The other party may have a defective
modem/FCU; try sending to another
machine.
 Check for line problems and noise.
Reference:
 TX level: NCU Parameter 01 (PSTN)
 Cable equalizer: G3 Switch 07 (PSTN)
 Dedicated TX parameters in Service
Program Mode
0-14
Non-standard post message
response code received
 Incompatible or defective remote terminal;
try sending to another machine.
 Noisy line; resend.
 Try adjusting the TX level and/or cable
equalizer settings.
 Replace the FCU.
Reference:
See error code 0-08.