Ricoh M281 Series - Page 859

Error Codes
SM 25 D255/D256 FAX OPTION
D255/D256
FAX OPTION
Code Meaning Suggested Cause/Action
0-15
The other terminal is not
capable of specific functions.
The other party is unable to accepting the
following functions, or the other party's memory
is full.
 Confidential RX
 Transfer function
 SEP/SUB/PWD/SID
0-16
CFR or FTT not detected after
modem training in confidential
or transfer mode
 Check the connection.
 Replace the FCU.
 Try adjusting the TX level and/or cable
equalizer settings.
 The other machine may have
disconnected, or it may be defective. Try
sending to another machine.
 If the RX signal level is too low, there may
be a line problem.
Reference:
See error code 0-08.
0-17
Communication was
interrupted by pressing [Stop]
 If [Stop] was not pressed and this error
keeps occurring, replace the operation
panel or the operation panel drive board.
0-20
Facsimile data not received
within 6 s of retraining
 Check the connection.
 Replace the FCU.
 Check for line problems.
 Try calling another fax machine.
 Try adjusting the reconstruction time for
the first line and/or RX cable equalizer
setting.
Reference:
Reconstruction time - G3 Switch 0A, Bit 6
RX cable equalizer - G3 Switch 07 (PSTN)